Page Comparison

...

1. Click on ‘add key point trigger’

2. Enter additional information in the ‘key point trigger configuration’

   1. assign a thumbnail to your menu button
      Optimal resolution: 324px x 324px

   2. assign a title to your menu button in the available languages

   3. Select a scenario. This selection should be the same scenario in which your application will be used

   4. Select a key point within the selected scenario. You can only choose from the active key points. Key points with a ‘hold’ are also filtered from the options.

   5. Select type of trigger (only for physical installations)

      1. on local device: only that device where this application is running will change

      2. on the exhibit: the whole exhibit where this device is part of, will change (when other devices are defined in the next keypoint)

      3. on all exhibits in the scenario: all the exhibits will change (when other devices are defined in the next keypoint)

Attention: if you select a different scenario than in which the application will be active, the key point trigger will not activate anything.

...